Uled



12INCH GAS PRICE DISPLAY

上一个
下一个
12INCH GAS PRICE DISPLAY


CABINET

 *Size:    32.9"x15.7"x3.2"
 *Depth: 60mm/80mm/100mm
 *Material: Iron
 *Cold rolled plate, electrostatic painting processing, High performance waterproof & anti-corrosion
 *Weatherproof for outdoor


LEDS CONFIGURATION

 *Ellipse lamps(546)
 *Super Brightness  >6000cd/m2
 *View angle: vertical >110°,Horizontal >110°


TECHNICAL SPECIFICATION

Operating environment:    Outdoor
Digit   Size:                     16” for 8.888 6” for 8/10 ultrabright LED digits
Viewing Angle:                >110° horizontal/vertical viewing angle.
Auto Dimming:               Brightness adjustment according to the change of ambient light or by hand
Transmission:                 RF (Optional RS485,RS232 or Ethernet )


SUPER LCD WIRELESS REMOTE CONTROLLER MANUAL

*Using the large capacity lithium battery,long standby time.
*Over voltage protection.If batteries run low during match just  plug charger into contrloller.
*Back light display for ease of viewing.
*Open and close handset: pls press and hold “ON/OFF” for 3 seconds until you hear a beep to switch on. close,pls press and hold “ON/OFF” for about 3 seconds too .
*REMARK:
    Wireless handset will auto power-off when no any input.
Update datas:
*Step1, inputing the channel number in <CH NO.> Edit Box. If current gas price changer of channel number is 1, pls input “01” .
*Step2, Inputing price in <price> Edit Box.
*Step3, Prssing “SEND” key, price is sended.
Setup The Display Channel Number:
*Step1. Press “OK” key enter , see picture below:
*Step2: Input passwared “   ” that is locked, can’t be modify. And enter modify interface.
*Step3:If you forget the current channel number, pls press “SEND” key belfore NO ANY INPUT. 
  In the meantime, the Gas Price Display will flash current channel number for three times.
*Step4: Respectively input current NO and New channel NO that you want.
*Eg:Current NO. IS 01, you want chage it to 15.
  Then you need input “01” in <Original NO> and “15” in <New NO> edit box.